If you have a pool in your backyard, then you may have a pool light or multiple lights. Pool lighting enhances the appeal of your pool while still allowing you to use and enjoy it safely after the sun goes down. However, you may find that your pool lights flicker or don't come on after a while. This is usually the moment when most homeowners wonder if it is necessary to replace the bulbs or the home itself.
Homeowners often want to know if it is necessary to drain their pool to repair the pool lights. You may be shocked to hear that pool lighting repair is not a very laborious or costly task. In 90% of inground pool lighting repair cases, it is not even necessary to completely lower the water level or completely drain the pool.
Pool Lighting Repair - How much does it cost to repair pool lights?
How much does it cost to repair a table lamp?
An average pool light bulb retails for $50-$60, while a new gasket costs about $35-$45. Depending on the location and complexity of the repair, the labor cost to perform the repair is typically $200-$250. In addition, the cost of new pool fixtures is $300-$400.
Diagnose what's wrong with your pool lighting
The fixture is a sealed glass housing that holds the bulb in place. The glass lens is screwed or clamped to the fixture and a rubber gasket makes it waterproof. The power cord is also sealed to the waterproof fixture. This is why they are called "wet niches. The interior of the niche is not sealed; it is submerged.
Reasons why pool lights don't work
There are several possible reasons why your pool light is not working. The most common problems fall into two categories. The light either doesn't work but has power, or it doesn't work but has no power. When the pool light is still energized, the problem is much easier to deal with. This indicates that the problem is limited to the fixture or bulb itself. As a corrective step, the bulb or the entire fixture must be replaced. One bulb can be much cheaper than the entire fixture, so this is usually the first thing we see. If it is decided that you need a new fixture, it is important to purchase the same fixture that you currently have. The fixture should match the niche.
There are some common problems with pool lights that can cause them to not work properly, and the diagnosis is not always as simple and dry as it could be. If the fixture itself has water in it, you may have a leak. This should usually be attributed to a defective lens gasket, the rubber seal between the lens and the housing. However, this may be due to the deterioration of the conduit seal over time. Unfortunately, despite what many DIY guides and friendly bloggers will tell you, each of these problems is something you should not try and fix.
Pool Light Repair Services - Pool Surgeons Offer Expert Advice
Pool lighting repair is not a good DIY project
If your pool lights are out, you may want to perform the repair work yourself. While pool lighting repair isn't exactly rocket science, we still strongly advise homeowners not to attempt DIY repairs on their lighting. Unless you are a licensed electrician, this job is best left to the professionals.
LightsLighting's pool service technicians are qualified to perform such repairs. This may involve determining if there is a short circuit and checking to see if the GFCI has been tripped. once on site, we are able to quickly remove and repair damaged pool lighting.
Why don't most pool service companies repair pool lights?
Most pool service companies are reluctant to provide pool lighting repairs simply because of the frequency of pool lighting leaks. There are many reasons why this happens, but the most common reason is that swimmers kick out the fixture and loosen it over time. This in itself can lead to repeat calls from homeowners wondering why the problem is happening again. The callback rate for this type of repair is so high that many repair companies choose not to offer this service. LightsLighting is one of the few pool service companies that offers pool lighting repair services.
Instant Messaging
